Features:

  • 1x Back Glass Cover Battery Door Replacement For Samsung Galaxy S7 G930
  • 1x ADHESIVE PRE-INSTALLED
  • This is not an easy job for someone who has no experience at all.
  • We will not be held responsibility for any damages to this part and your device caused by your wrong operation.
  • Therefore It Is Highly Recommended That You Use a Professional To Change You Screen To Minimize The Risk of Damage To Your Device.
Excellent glass cover, looks just like the original

Excellent replacement cover for your S7, even has Samsung printing on the back.There is glue around the edges so resealing this cover to your case is no problem. Please pay close attention to the picture, this is the glass cover only, it has no camera cover. As long as your camera cover is not damaged removing it and installing it in this cover is simple. There is not any glue around the camera opening so you'll either need to reuse some of the original adhesive (tricky but doable), use double face tape, or do what I did and just snap it in place. The later is not waterproof and would be ill advised unless you have a protective cover that shields the lens from being pushed on. A word of warning from experience. While removing the back cover of your S7 is easy it is also easy to damage it (hence my purchase of this cover).

Superb Replacement Back!!!

Well worth the money. Quality looks very good and looks original (Graphics on backglass look the same as original. Where mine said Verizon, this one says Samsung. Well packaged. I ordered this and the camera lens kit so I could swap them out without worrying about the old lens and adhesive. Heat up the old one, pry up in sections as you heat. Once the old one is off clean the residue off the sealing surface, qtip with alcohol, place new back in place. Fit was perfect!!

Plastic not Glass, better this way in my eyes....

First things first, it is plastic not glass. Definately not OEM. That said I was happy it was plastic instead of glass. Easier to install and no risk of shattering during install. Literally the only way you could tell this is not OEM once installed would be to remove it off the phone to see if it was glass or plastic. For the cost of the item I am extremely pleased. Make sure you fllow the instructions and take your time. It makes all the difference when done properly.

Worked great

I got this because I wasn't sure my case back removal skills would be good. I got the original back off without breaking it, but the old adhesive pulled the paint off leaving a scar. Couldn't have that so I installed the new cover after pulling the old lens off the old cover. All went well and the fit and adhesive are great. Further note: I refinished the paint on the old cover's inside and all is good so I have a spare cover as well.

Great product, but read these instructions.

Extremely easy to put on and looks just like original did from a view standpoint. Make sure to heat your old one up for a while with a hairdryer. Like 5 minutes or so until you feel it moving a little when you twist. Then use something thinner than a credit card but sturdy to pry it up around the edges. If you didn't buy a replacement camera cover you can carefully pop your old one out of your old back case and snap it into your new one (if your old one wasn't damaged). The cover comes with plenty of stickiness and is working great 2 weeks into my use of it.

Worked for me - light weight feeling and other reviews make it confusing.

i got it installed and the person did not say it was plastic, so not sure why other reviews are bad. It does feel light but I believe it's just the feeling of the type of material used. I am assuming because it's tempared glass and meant to be ultra light it seems to be like plastic.

great product

The only con to this one is the fact that you have to buy a camera cover to go with it, since it doesn't have the adhesive to place the old camera cover, and it is just an empty hole on the camera location. The shipping and packaging was excellent and the back piece of plastic has 2 parts, so you can install the camera glass before having the main adhesive exposed. That makes it so much easier, since you don't have to work around the main adhesive and possibly ruin your water protection.

Recommend!

I like it! Easy to replace with their tools. I used a hair dryer and expected it to take much longer than it did. Well packaged and seems like a quality product so far. It hasnt cracked yet like the original one, at least. 🤷♀️

Needed for any internal repairs because when opened, waterproof adhesive breaks

Great replacement for S7 backing. Definitely OEM. Easy to install. I highly recommend this product if you are doing repairs inside an S7 because when opened, the S7's waterproofing adhesive breaks

Recommend it

it was a good product. I recommend it to those who need one.

Full Reviews